24eNews – Exclusive Tech News Site 24/7

Exclusive Tech News Site 24/7

Here’s how to properly clean any type of cell phone case or case


Depending on the material of your phone case, the cleaning products and the following steps are one or the other.

The case or case is an essential element in protecting your mobile phone from possible bumps or falls. Like the terminal itself, ten times dirtier than a toilet, The pod can also preserve microbes, bacteria and fungi dangerous to your health.

While antimicrobial covers already exist, it is best to learn how to do it Properly clean any type of phone case or case to always keep it away from dirt.

In this guide we will explain how to clean that Covers made of plastic, wood, silicone and leather. Depending on the material, the cleaning agents and the steps to be followed vary.

Before your phone becomes a potential source of infection, clean it to remove any accumulated dirt. Next we explain how to do it based on the material it was made with.


Clean the plastic cover

Plastic covers withstand cleaning processes well

Although their popularity has decreased over time with the advent of silicone cases, plastic cases are still a permanent option to protect the cellphone.

Plastic covers, especially those made of hard plastic, can be cleaned easily thanks to its resistance to products such as bleach or alcohol. If you prefer not to handle such strong substances, you always have the option of cleaning your phone case with detergent, at least with plastic ones.

If you have a cover made of this material and you want to learn how to clean it properly, These are the materials you will need and the steps to follow.

Necessary materials

Steps to clean a plastic wrap

  1. Take the phone out of the case to prevent water from entering the case during the cleaning process.

  2. Put on the gloves to avoid possible incidents when handling the bleach.

  3. Add in a container one tablespoon of bleach for each cup of water until there is enough fluid to insert the cover.

  4. Submerge the cover in the solution with bleach and water for about 10 minutes.

  5. Remove the sleeve and scrub it with a toothbrush or sponge remove accumulated dirt.

  6. Rinse the carcass well in water to remove residual bleach.

  7. Dry the water with a soft cloth and finally let it off Stop air drying for half an hour before covering his cell phone again.

In case you don’t want to use bleach when cleaning the case, you can Replace detergent. The steps are similar: mix it with water, soak the case and rub it with a toothbrush, rinse and dry it before putting it back on the phone.

Clean wooden box

Pixel 3 wooden case

This is what a wooden box looks like on Google Pixel 3

Wooden sleeves require careful cleaning that does not affect the material. If you don’t know, we need to sort it out Water is not a good friend of wood. When wood absorbs water, it swells up; When it identifies it, it contracts.

In any case, the wood is affected and changes its original state when you use water to purify it. Hence, you need to be extra careful if you want to properly clean the wooden case of your cellphone.

You can avoid potential problems during the cleaning process by: a special solution created with vinegarAlways remember that you shouldn’t use it to soak the wooden box. These are the materials and steps you will need to clean a wooden phone case.

Necessary materials

  • vinegar

  • water

  • Soft cloth or rag

  • Spray can


Steps to clean a wooden box

  1. Fill the spray can with two thirds of water and one third of vinegar. Then mix well to prepare the solution.

  2. Pour the solution into the wooden cabinet and Clean it with a cloth getting rid of the accumulated dirt, always with the care of Do not wet the cover too much.

  3. Dry the cover with a Cloth or paper to remove the solution applied.


Clean the silicone or rubber cover

OnePlus 6T case

The official cover of the OnePlus 6T is silicone

Silicone or rubber covers are the most common these days because they offer strength without sacrificing flexibility. If we compare them to the hard plastic trays, these are silicone trays something more sensitiveTherefore, we cannot use the bleaching solution mentioned in the other case.

Before recommending the materials needed for proper cleaning and the steps below, let’s remember that it does too Disinfectant wipes to clean your mobile phone in just a few seconds. In extreme cases, these wipes can also help with cleaning the connector cover.

In this case, the most common way to clean a silicone or rubber cover is to use a mixture of soap and water, which is milder than bleach. If the case is excessively dirty, you can Also use a solution with sodium bicarbonatewhich cleans the silicone without damaging it. This is the list of materials required and the steps to clean a silicone or rubber sleeve.

Necessary materials

Steps to clean a silicone or rubber case

  1. Fill a container with Pour hot water and washing-up liquid. Mix it to create the cleaning solution.

  2. Dip the sponge in the soapy water and Use it to clean the case. To get to the most hidden spots, use the toothbrush after running it on the soapy water. If the dirt remains Apply some baking soda to the carcass and rub it with your toothbrush.

  3. Rinse the cover with water to clean the remains of soap and bicarbonate.

  4. Dry the cover with a towel or a dry cloth. Then leave the carcass outdoors for about half an hour to finish drying. Finally, protect your cell phone again with the clean case.

As soon as this cleaning is completed, you can clean the silicone cover every week Disinfectant wipes like these from KsixThis will allow you to keep the cover away from microbes and bacteria without spending as much time cleaning it up.


Clean the leather bag

leather bag

Leather is one of the most sensitive materials to clean

Another most common material in cell phone cases is leather. If you have an enclosure like this, this is what you should know Leather is one of the most sensitive materials Therefore, you should be very careful when cleaning. Forget about bleach or alcohol. To properly clean a leather bag, you need to use softer products.

You must too Protect your leather bag from heat, moisture, oil or make-upwhich can also damage it. Next we will talk about the necessary materials and steps to clean a leather bag. Spoiler: The most recommended product is a leather care product.

Necessary materials


Steps to clean a leather case

  1. Fill a container with Pour hot water and washing-up liquid. Mix it to create the cleaning solution.

  2. Moisten the cloth lightly with the soap-water mixture and Wipe the leather bag with it. Important: never pour the solution directly into the sleeve.

  3. Use another dry cloth for this Remove any remaining water in the holster.

  4. If the leather case doesn’t fit, you can Use a leather conditioner to 100% clean it. Follow the instructions on the product to complete the process correctly.

If you want to know everything about Android, you have to follow our Instagram or join our Telegram channel.

Follow 24enews